Generally speaking, after buying a new car, you need to drive on the road often, and you need to drive inside. This is called the run-in period. So for the tumble dryer, this running-in period is also needed. This break-in period is very important. Generally speaking, the number of failures and lifespan of the tumble dryer are very directly related to this break-in period. Therefore, after purchasing the tumble dryer, the tumble dryer must be maintained during the running-in period of the tumble dryer, otherwise, the failure of the tumble dryer will increase in daily production in the future.

    Dingli experts introduce to you the matters needing attention during the running-in period of the tumble dryer:

    1. Pay attention to frequently check the level of lubricating oil, hydraulic oil, coolant, brake fluid and fuel (water), and check the tightness of the whole machine. At the same time, the lubrication of each lubrication point should be strengthened. It is recommended that during the running-in period, grease should be added to each shift to supplement the grease (except for special requirements).

    2. Since the tumble dryer is a special machine, the operator should be trained by the manufacturer before the machine can fully understand its structure and performance. Before the machine runs, you must first browse the use of protection instructions, and operate and maintain according to the instructions.

    3. During the running-in period, the machine should be maintained, inspected and adjusted, and the oil should be changed.

    4. Pay attention to the running-in period of the working load. The working period during the running-in period generally does not exceed 80% of the rated working load, and an appropriate workload is allocated to prevent the machine from running continuously for a long time and causing overheating.

    5. Keep the tumble dryer clean, adjust and tighten loose parts in time to avoid aggravating the wear of the parts or the loss of the parts due to the looseness.

    6. Pay attention to check the parts frequently. If there is any abnormality, stop at the time to eliminate it. Before finding the cause, if the fault is not eliminated, the operation should be ended.

    Well, the above is Zhengzhou Dingli explained to you the maintenance work of the tumble dryer during the running-in period. I hope that the customer should pay attention to it, so as not to cause economic losses to the future daily output.