Coal recycling needs to be dehydrated and dried. What is the process of coal dehydration and drying technology? Today I will give you a brief introduction and share the video of Dingli's new coal dryer.

    Dingli Coal Dryer is mainly composed of heat source, belt feeder, rotary drum, belt discharger, induced draft fan, cyclone dust collector, bag dust collector and power distribution cabinet. The working principle of the equipment is as follows: after the wet material enters the drying drum, it is divided into the following working areas: First, the material guide area, where coal enters this area and contacts with high temperature hot air to quickly evaporate water, and the material is copied under the guide plate with a large guide angle Is introduced into the next working area; the second is the copy board area where coal is picked up by the copy board to form a material curtain state. At this time, the material is fully in contact with the hot air, and the moisture in the coal quickly evaporates into water vapor, and the water vapor is immediately The induced draft fan draws away, so as to achieve the purpose of drying; coal is dried in this area into a low-moisture loose state. After heat exchange, the material reaches the required moisture state and enters the discharge area; the third is the discharge area, the drum is in this area Without copy board, the material rolls and slides to the discharge port in this area to complete the entire drying process.

    The above is the operation video of Dingli Coal Drying Equipment. A large amount of coal can be quickly dehydrated and dried by Dingli Dryer. Dingli Coal Dryer can process 300 tons to 3000 tons per day. The equipment has a large processing capacity and can be continuously produced. The production line can be matched A variety of heat sources, please leave a message to consult.